enLink Status-P – LoRa Wireless Pulse Counter

enLink Status-P counts meter pulses, or monitors switch contact status on up to two channels and transmits the accumulated data to the cloud using long range LoRa wireless where it can be displayed and analysed.

Battery powered, enLink Pulse is the easiest, fastest way to access your energy data in real time.

enLink Status-P has two S0 standard pulse inputs to collect data from electricity, gas, water, heat or any other pulse enabled meter.

Long range LoRa wireless transmits the data for up to 16 km with deep in building penetration of 1 – 3 km without repeaters.

Sensor Characteristics

Data can be received by any LoRaWAN compliant gateway or enLink Hub to forward data to the Cloud where it can be analysed using enVision or third-party applications.

When used with enLink Hub, sensor data can be sent via long range LoRa wireless and converted to Modbus IP register values for integration with EMS/BMS, SCADA or monitoring equipment.

enLink Status-P is also available with an additional seal to achieve IP66 (NEMA4) protection.

Battery Powered

  • Battery life 3+ years*
  • Can be installed in minutes

Easy installation & setup

  • Compact size 129mm x 67mm x 41mm
  • Available in 868MHz and 915MHz frequencies.
  • Meter pulse indicator
  • LED Signal strength indicator
  • LED Battery level indicator
  • Full configuration and monitoring via USB
  • Available with IP67 (NEMA 4X, 13) seal

Applications

Typical applications include

  • Meter pulse counting for energy management
  • Dry contact status monitoring
  • Monitoring doors and windows
  • Restricted area monitoring
  • Data Centre cabinet monitoring
  • Freezer and cooler doors
  • Garage door monitoring

Case Studies incorporating enLink Status-P Sensors

Pilkington

9th August 2018